Cellulose nanocrystal interactions probed by thin film swelling to predict dispersibility

15, June, 2016

A new publication in Nanoscale and three poster awards at TAPPI nano 2016 for the group of Emily Cranston at McMaster university, Canada.

CONGRATULATIONS!

tappi_nano_3rd_place_crop.jpg

From left: Emily Cranston, Michael Reid, Stephanie Kedzior and Johana Kuncova-Kallio

Cellulose nanocrystal interactions probed by thin film swelling to predict dispersibility

The production of well-dispersed reinforced polymer nanocomposites has been limited due to poor understanding of the interactions between components. Measuring the cohesive particle–particle interactions and the adhesive particle–polymer interactions is challenging due to nanoscale dimensions and poor colloidal stability of nanoparticles in many solvents. We demonstrate a new cohesive interaction measurement method using cellulose nanocrystals (CNCs) as a model system; CNCs have recently gained attention in the composites community due to their mechanical strength and renewable nature. Multi-parametric surface plasmon resonance spectroscopy (MP-SPR) was used to monitor the swelling of CNC thin films to elucidate the primary forces between CNCs.

This was achieved by measuring swelling in situ in water, acetone, methanol, acetonitrile, isopropanol, and ethanol and relating the degree of swelling to solvent properties. Films swelled the most in water where we estimate 1.2–1.6 nm spacings between CNCs (or 4–6 molecular layers of water). Furthermore, a correlation was found between film swelling and the solvent's Hildebrand solubility parameter (R2 = 0.9068). The hydrogen bonding component of the solubility parameters was more closely linked to swelling than the polar or dispersive components. The films remained intact in all solvents, and using DLVO theory we have identified van der Waals forces as the main cohesive interaction between CNCs. The trends observed suggest that solvents (and polymers) alone are not sufficient to overcome CNC–CNC cohesion and that external energy is required to break CNC agglomerates. This work not only demonstrates that SPR can be used as a tool to measure cohesive particle–particle interactions but additionally advances our fundamental understanding of CNC interactions which is necessary for the design of cellulose nanocomposites.

Ref: Cellulose nanocrystal interactions probed by thin film swelling to predict dispersibility, Michael S. Reid, Marco Villalobos and Emily D. Cranston, Nanoscale, 2016, Advance Article, DOI: 10.1039/C6NR01737A